Stop By or Give Us a Call to Take Advantage of Special Ordering!

Valspa Concrete and Masonry Natural Look Protective Seale

Valspar

This sealer locks out weather and scuffs with a tough, penetrating layer of invisible protection.

  • Invisible finish, silicone-infused to protect without altering appearance
  • Seals out weather and household chemicals
  • Easy to apply, dries to the touch in 2 hours
  • Usage
    Exterior aggregate, concrete, brick, pavers, masonry, mortar and flagstone. Do not use on garage floors.
  • Prep
    All surfaces must be clean, dry and free of all loose, peeling paint or contaminants. Bare concrete: New concrete, masonry surfaces and mortar should be cured 60 days. Previously sealed surfaces: Clean with an all-purpose cleaner (TSP or substitute). Previously sealed surfaces must be porous and able to accept additional sealer. Test surface porosity before sealing: Avoid using this product on nonporous, sealed surfaces. To test, place a few drops of water on the surface. If water sinks in, the surface is porous enough to use this finish. If water remains on the surface, do not use.
  • Application
    Use a roller or low-pressure, garden-type sprayer. While the first coat is still wet, apply a second coat to maximize protection. Allow 5–10 minutes for final penetration, then use a clean, dry cloth to wipe off all excess that did not soak into the surface. Do not pond or puddle this product.
  • Dry Time
    Dry Time @ 77 °F and 50 % Relative Humidity
    To The Touch: 1 hour 1 hour
    Recoat: N/A
  • Clean-up & Disposal
    Clean up with warm, soapy water.